INTEL/manual_sk4+5+7
shiny.
FAQ
​​
Q: How safe is this "knife"?
A: All tips are rounded enough to remove the sharp point, but still appear pointy overall. All edges are completely square and dull. The electronics are harmless. If the blade breaks, the broken edges will be sharp.
​​
Q: How bright is it?
A: Naturally it looks the best in darker environments, and disappears entirely in sunlight. It is visible in a normally lit room, but it's not as cool. The LED colors, blade color, and blade type are also factors. The LEDs and battery are small - don't expect a lightsaber.
​
Q: I seem to have an issue with flickering, what's going on?
A: Sometimes the battery can become slightly loose - the lights still come on, but one might appear dim or flicker. The fix is simple - remove the handle screws with a 2.5mm hex wrench. While pressing on the battery, use a flat screwdriver to bend the battery tab down so that the battery has no wiggle room. I do this to all units during assembly, but there are scenarios where it needs to be reapplied (temperature cycles, drops, battery replacement, human error, etc.).
​​​
Q: How do I change the battery?
A: Remove the screws in the handle with a 2.5mm hex wrench. Split the handle, pry out the coin cell, and replace. Bend the battery tab down to help it firmly hold the battery. CR2032 coin cell batteries can be purchased at most general stores.
​
Q: How sturdy/durable is it?
A: I have dropped them on wood dozens of times without breaking the blade. It only weighs 3oz and the blade is semi-flexible, so it's hard for it to break itself with just a fall. You could probably snap the blade if you throw it as hard as you can at a cement floor and it hits just right, or if you bend the blade excessively sideways. I have also yet to break or wear out the electronics - they are very simple and glued in place. That said, if you toss it around enough, something should break eventually.
​
Q: Is it waterproof?
A: No, but it would take a lot of water to be a problem. If water gets deep inside it could short the electronics. Immediately turn it off, remove the battery ASAP, and dry it completely, and it should continue working.
​​
Q: What if it does break? (WARRANTY INFO)
A: If the electronics break within 7 days, I'll replace the handle assembly. If the blade is broken in shipping, I'll replace it. If the blade breaks any other way, replacements are available for purchase.
​
Q: Can it be fixed?
A: Most likely, yes. The electronics are potted with hot glue, which can be removed. The electronics and blade can be replaced. The only damage I've been unable to fully fix in the field is handles that have been warped by excessive heat.
​​
Q: Can I order a custom build?
A: The available options are all within the listing. I don't make custom blades, sorry!
​
Download the Mk.5 quick guide here.
Download the Mk.7 quick guide here.